Whether you are planning a repair or you have an emergency requirement, we are available at short notice to offer a fast repair service in your home or business. A lot of electrical repairs include replacement and installation of systems and appliances at your property. These include:
Fault Finding means to locate the problem and then fix it. Electrical fault finding can take a long time or a short time depending on the skill of the emergency electrician doing the work.
Our electrical technicians are specially trained in electrical fault finding procedure. For the customer, this means fast and accurate troubleshooting.
Often on findings from a Periodic Inspection, we find that two or more circuits have been wired into the same fuse / MCB (Miniature Circuit Breaker) or do not have the correct rating of overload protection, leaving your home at risk to fire.
The latest BS7671 regulations stipulate that all circuits must be protected by an RCD (Residual Circuit Device). Many homes don’t have an RCD, and this is crucial as it protects your home from and fires and potentially electric shocks.
Since 2008 RCDs have to be installed on every cable / circuit in the home reg:522.6.7/8. BS7671- Amendment 1 2011 IEE Regulations. They are fitted into every new type 17th Edition consumer units we install and must trip if more than 30mA of fault current exists (Potentially 100mA could be fatal so this trips out before that amount can be present). The RCD must trip within 200mS (0.2s).
The latest consumer units have MCBs to protect the circuits from overload i.e. if a cable is rated at 10amps then an MCB must be rated below that, so it will trip instead of the cable getting hot. Also the new consumers units have two RCDs for fault protection. The reason for having two is so the circuits (sockets and lights etc) can be split, and then if a fault occurs you don’t lose all the electricity in the house so you can see in the dark and the fridge can be plugged in.
The main tails and main earth are checked and updated if required and included in the price. All our consumer units carry a 12 month warranty and an Electrical Installation Certificate is issued on completion of the work.
Problems with water temperature are often an indication of a faulty immersion heater
Faults to immersion heaters are often caused by hard water (lime scale) build up within the tank. This eats away at the copper element and causes it to short circuit or sometimes just not heat up. The element is encased inside the tank of water and requires a skilled, experienced workman to replace it. The water has to be drained away before the element can be removed. Great care has to be taken not to cause any leaks or air locks on refilling the tank.
Other faults include the power failure to the switch or element which can be carried out on our hourly rate.
